Signature Gator Seal for Natural Stone zero gloss, water based sealer with color enhancer is made of silicone based polymers. This sealer penetrates deep into the natural stones, thus reducing the oil and dirt penetration, as well as protecting them from the corrosion of de-icing salt. Color enhancer Water-based Non film-former Easier to clean and maintain Works at above 32ºF (0°C) Zero gloss Helps Resist Corrosion from de-icing salt Ultraviolet rays effects Motor oil and grease stains Application & Installation FOR NATURAL STONES: ALWAYS TEST the product on a small hidden area of approximately 4 sq. ft. (0.4 sq. m.) to ensure the results will meet your expectations. Remove all the stains from the natural stones, using Gator Clean products. Use Gator Clean Sealer Stripper to remove any unknown coating that remains on the natural stone surface. Remove all contaminated jointing material and replace with Gator Polymeric Sand. Follow the instructions on the back of the bags for proper sand installation. Wait at least 48 hours at a minimum temperature of 40°F (4°C) and no rain for the Gator Polymeric Sand to properly harden. Clean the entire surface with the Gator Efflorescence Cleaner. This product will remove the efflorescence trapped in the natural stone pores as well as thoroughly clean the surface for proper sealer adhesion. Wait at least 48 hours at a minimum temperature of 40°F (4°C) and no rain so the sand & natural stone surface are dry. Dry surface for 24-72 hrs prior to apply sealer. Apply one (1) coat of Signature Series Natural Stone Sealer using a sprayer (HVLP), nap roller (5-10 mm), squeegee, sponge or rag. Apply in 60 sq. ft. (5.6 sq. m.) sections at a time. Use a foam roller or squeegee to remove excess sealer from the surface. Allow remaining sealer to penetrate 5-10 minutes. Wipe and remove any excess sealer with clean, dry, lint-free cotton cloths. Repeat after 30 minutes if no.
Color enhancer, Water-based, Non film-former, Easier to clean and maintain
Works at above 32ºF (0°C) Zero gloss. Helps Resist, Corrosion from de-icing salt, Ultraviolet rays effects, Motor oil and grease stains.
Coverage Products Area, Granite 400-600 sq. ft. per gallon, Travertine 500-700 sq. ft. per gallon.
Coverage Products Area , Limestone 300-500 sq. ft. per gallon, Bluestone 200-400 sq. ft. per gallon.